Holing/cutting instructions

ISTRUCTION FOR THE LINEAR CUT OF THE CRYSTAL CLASS:
WATER CUTTING MACHINE WITH WIDDIAM DIAMOND DISC
We recommend to do such operation with a water cooled cutting machine with diamond disc,
making sure to always have water in order not to damage the diamond disc and the crystal glass.

Widdiam diamond disc:
DISC: Ø 110 mm - for shaped cut
DISC: Ø 300 mm - for linear cut

It is recommended to clean the sides of the with glass abrasive paper (grit 320 or 400)
N.B.: kit of protective material available to be used after any operation of cutting/holing


ISTRUCTION FOR THE HOLING:
HOLING WITH DIAMOND CUPS DRILL COLUMN
The drill must have the possibility of adjusting the rpm, it recommended to use diamond cups. Begin the holing from the protection side, continuing till half way through the thickness, turn on the other side the glass slab and continue the holing till reaching the other side. It is suggested during the holing to keep the diamond cups always thoroughly wet.

FORM Ø 5 to 80 mm - 1500/2000 rpm

It is recommended to clean the sides of the with glass abrasive paper (grit 320 or 400)
N.B.: kit of protective material available to be used after any operation of cutting/holing